-
Hello, I am using an ESP32 development board with new latest version of Tasmota (14.0.0). I tried to create a kind of prototype to check how shutters or blinds are exposed via matter to Homekit and Google Home. Therefore I created to relays in the configuration (the GPIOs are not connected), added the commands SetOption80 1 The startup looks like this: 00:00:00.515 SHT: About to load settings from file /.drvset027 Interlock like this: 13:56:23.535 CMD: Interlock Config looks like this: 13:49:22.531 RSL: RESULT = {"NAME":"ESP32-DevKit","GPIO":[1,1,1,1,1,1,1,1,1,1,1,1,1,1,1,1,0,1,1,1,0,1,1,1,0,0,0,0,1,1,1,1,1,0,0,1],"FLAG":0,"BASE":1} Status and Status 8 like this: 13:57:30.112 RSL: STATUS = {"Status":{"Module":1,"DeviceName":"Tasmota","FriendlyName":["Tasmota","Tasmota2"],"Topic":"tasmota_9A4B90","ButtonTopic":"0","Power":"00","PowerLock":"00","PowerOnState":3,"LedState":1,"LedMask":"FFFF","SaveData":1,"SaveState":1,"SwitchTopic":"0","SwitchMode":[0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0],"ButtonRetain":0,"SwitchRetain":0,"SensorRetain":0,"PowerRetain":0,"InfoRetain":0,"StateRetain":0,"StatusRetain":0}} The UI displays up and down arrows, open close sliders and ON/OFF above the arrows, the virtual shutter can be opened and closed. 13:58:54.881 RSL: RESULT = {"POWER1":"ON"} 13:59:04.930 RSL: RESULT = {"Shutter1":{"Position":100,"Direction":0,"Target":100,"Tilt":0}} Now I want to expose the shutter via matter to Homekit. I added one device to matter (type Shutter and parameter 1??). When I connect to Homekit, the device (shutter) is added, but Homekit says there is no answer. Same in Google Home. What parameter do I have to add? 13:50:50.558 MTR: New Connection (CASE id=7896) from [fe80::ca0:6963:e670:12f7%st1]:54118 Regards, |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment
-
I can answer my own question. Everything works when settings 0 as the parameter, not 1. I do not know if this is a bug, but setting 0 exposes the blinds Shutter 1 as a matter device. However I think I found another bug, when adding shutter + tilt the device hangs after about 20 seconds and has to be rebooted manually. I will open an issue. |
Beta Was this translation helpful? Give feedback.
I can answer my own question. Everything works when settings 0 as the parameter, not 1. I do not know if this is a bug, but setting 0 exposes the blinds Shutter 1 as a matter device. However I think I found another bug, when adding shutter + tilt the device hangs after about 20 seconds and has to be rebooted manually. I will open an issue.